Difference between revisions of "IBM-Neutron"
m |
m |
||
Line 1: | Line 1: | ||
− | IBM SDN-VE Plugin | + | |
+ | <br /> | ||
+ | <br /> | ||
+ | = IBM SDN-VE Plugin = | ||
+ | ---------------------- | ||
== Overview == | == Overview == | ||
Line 18: | Line 22: | ||
'''controller_ips = 127.0.0.1,127.0.0.2''' | '''controller_ips = 127.0.0.1,127.0.0.2''' | ||
− | IBM SDN-VE Plugin Unit Tests | + | == IBM SDN-VE Plugin Unit Tests == |
<pre><nowiki> | <pre><nowiki> |
Revision as of 17:33, 5 February 2014
IBM SDN-VE Plugin
Overview
This plugin implements Neutron v2 APIs by using IBM-SDNVE controller.
Configuration
In order to use this plugin, the core_plugin in neutron.conf should be set as follows:
core_plugin = neutron.plugins.ibm.sdnve_neutron_plugin.SdnvePluginV2
It should be noted that this plugin does not support security groups.
Furthermore, sdnve_neutron_plugin.ini is used to set plugin specific parameters.
The IP address of the controller or a list of IP addresses can be used to point to the IBM SDN-VE controller.
controller_ips = 127.0.0.1,127.0.0.2
IBM SDN-VE Plugin Unit Tests
cd <neutron_path> ./run_tests.sh neutron.tests.unit.ibm.test_sdnve_plugin