Difference between revisions of "Tacker/Installation"

Revision as of 19:58, 13 July 2015

1) Pull devstack repo for stable kilo branch

3) A sample local.conf is placed at https://github.com/stackforge/tacker/devstack/samples/local.conf.sample. Copy the local.conf in to devstack directory and customize it based on your environment settings.

4) Run stack.sh

This is to be done after successfully installation Tacker as mentioned above

1) Pull Tacker Horizon repo from,

Follow the README.md instruction to install it on top of horizon (say in /opt/stack/horizon)

Note: once tacker devstack patch is integrated tacker-horizon will be automatically installed when tacker is enabled in devstack

1) Follow the examples in tacker-vnf.sh exercise file to try out tacker commands,

tacker vnfd-create --name ${VNFD_NAME} --vnfd "${VNFD_TOSCA_YAML}

tacker vnf-create --name vnf-name --vnfd-id ${VNFD_ID}

tacker vnf-update --config "${CONFIG_DATA_YAML} ${VNFD_ID}

2) If command-line tacker works fine, try out Tacker using Horizon (NFV left menu entry)

@@ Line 2: / Line 2: @@
 == Tacker Installation Guide ==
-) Pull Tacker devstack repo
+) Pull devstack repo for stable kilo branch
-git clone  -b tacker-devstack https://github.com/srics/devstack
+https://github.com/openstack-dev/devstack
-Note: This will be transitioned to a devstack plugin within tacker repo
+) A sample local.conf is placed at https://github.com/stackforge/tacker/devstack/samples/local.conf.sample. Copy the local.conf in to devstack directory and customize it based on your environment settings.
-) Pre Installation steps
-    Create mgmt provider network L2 bridge,
-    sudo ovs-vsctl add-br br-mgmt0
-) Tacker devstack local.conf
- * Refer to this sample local.conf  https://github.com/srics/devstack/blob/tacker-devstack/sample.local.conf
- * Make sure you set appropriate phynet / bridge-mapping for br-mgmt0 in the neutron.conf ML2 configuration section
 ) Run stack.sh
-) Post Installation steps
-   Once successfully stacked up run sample tacker setup script at https://github.com/srics/devstack/blob/tacker-devstack/sample.tacker-setup.sh .  This script will configure br-mgmt0 and  the required neutron networks (including the neutron provider network mapped to br-mgmt0)
 == Tacker Horizon Installation Guide ==