[ DRAFT ]
- Blueprint: https://blueprints.launchpad.net/ironic/+spec/ironic-snmp-power-driver
- Created: 28th April 2014
- Author: Stig Telfer
Ironic's ability to control power to physical hardware is limited to server hardware that embeds an implementation of power management.
This is limiting in two ways:
- Commodity motherboards do not integrate a baseboard management controller, particularly cost-sensitive ones.
- Other classes of physical equipment (network switches and middleboxes for example) do not offer integrated power management.
This blueprint proposes widening Ironic’s capabilities by adding support for a class of power controllers that are implement SNMP interfaces, including smart PDUs with network connectivity. For example, remote control of node power can be achieved by enabling or disabling sockets on a rack power strip.
SNMP appears to be a good choice for the following reasons:
- As an interface it cannot change between device firmware versions, whereas human-readable interfaces (HTTP, CLI) could.
- It appears to be the protocol with widest deployment.
The proposal would use data definitions to support SNMP power control interfaces from multiple vendors. Power usage monitoring is also possible with smart PDUs, but is beyond the scope of this proposal.
Use Case Scenarios
A cost-conscious user may want to use bare metal compute without the addition expense of server equipment that supports integrated power management.
A power-conscious user may want to power off sections of network while attached server hardware is also out of service.
The proposed design would use PySNMP to interface with power control devices.
For compute servers, power control addressing data would be attached as additional attributes to Ironic node driver info:
- snmp_driver - The class of power driver to interface with. This will identify a vendor-specific MIB interface to use.
- snmp_address - The IP address of the power driver.
- snmp_community - The write community to use for changing power state.
- snmp_outlet - The power outlet number (1-based) on the power device.
This project would have a dependency on the PySNMP module
- All network addresses and outlet numberings for power control devices would be maintained as a statically-mapped data.
- The management interfaces of power control devices would be reachable from Ironic services.