Ironic/TripleO
< Ironic
Using Ironic with TripleO
In this section, we will go over how to set up Ironic within the TripleO enviroment.
- Note: TripleO is under rapid development and may invalidate this walk-through.
If not familiar with TripleO and / or have not used the DiskImage-Builder (DIB) tool before, please read and familiarize yourself with the TripleO story. Here are some good starting points:
Check out tripleo-incubator master.
Switch the undercloud to build with Ironic by doing:
export USE_IRONIC=1
Then, follow TripleO's Devtest-Doc.
After setup-baremetal is called in both the seed and undercloud stages you can use
ironic node-list
to list nodes and
ironic node-show $NODE
to view nodes.
You can now control the power state of this node with this command:
ironic node-set-power-state $NODE [on|off|reboot]