Difference between revisions of "GroupBasedPolicy/InstallCiscoACI"
Mike Cohen (talk | contribs) (→Installing and Running GBP with Cisco APIC) |
Mike Cohen (talk | contribs) (→Devstack Installation) |
||
| Line 39: | Line 39: | ||
</pre> | </pre> | ||
| − | 5. | + | 5. pip install apicapi |
| − | 6. Ensure your uplink to ACI fabric is up and a port is created on OVS. | + | 6. ./stack.sh |
| + | |||
| + | 7. Ensure your uplink to ACI fabric is up and a port is created on OVS. | ||
<pre> | <pre> | ||
sudo ovs-vsctl add-port br-em1 eth1 | sudo ovs-vsctl add-port br-em1 eth1 | ||
</pre> | </pre> | ||
| − | + | 8. source openrc demo demo | |
| − | + | 9. Use the "gbp" CLI binary ("gbp --help" will give you the commands) | |
Revision as of 17:28, 12 January 2015
Installing and Running GBP with Cisco APIC
The following are a set of instructions for installing and working with the Cisco APIC:
Devstack Installation
0. Install Ubuntu 14.04.
1. git clone http://github.com/group-policy/devstack -b stable/juno-gbp-apic
2. cd devstack
3. Configure the local.conf file.
- Set HOST_IP
- Set Q_PLUGIN_EXTRA_CONF_PATH. This should point to the path where the ml2_conf_cisco.ini file resides. Note it should NOT start with a /.
4. Configure ml2_conf_cisco.ini at the path you chose. For complete instructions on available options see this document. An example file would look like this:
[DEFAULT] # Unique Name for identifying the Openstack Cluster apic_system_id=gbp3 [ml2_cisco_apic] # Host Name for the APIC Controller apic_hosts=172.31.100.1 # Username for the APIC Controller apic_username=admin # Password for the APIC Controller apic_password=cisco123 # How to map names to APIC: use_uuid or use_name apic_name_mapping=use_name # Switch to hypervisor port mapping [apic_switch:101] ubuntu-gbp=1/5
5. pip install apicapi
6. ./stack.sh
7. Ensure your uplink to ACI fabric is up and a port is created on OVS.
sudo ovs-vsctl add-port br-em1 eth1
8. source openrc demo demo
9. Use the "gbp" CLI binary ("gbp --help" will give you the commands)
